How to Test IPM IGBT Diode & Gate Junction with DMM – 6 Pack Powerex PM150CVA120
Explanation on How to Test the Diode and Gate Junction of a 6 Pack IPM IGBT with a DMM Digital Multi Meter with IPM IGBT Schematic – Powerex PM150CVA120.
Click here to Subscribe to our Youtube Channel: http://goo.gl/DDfVab
https://www.youtube.com/user/KGittemeier
IGBT IPM Intelligent Power Module Diode and Junction Test Procedure using a DMM.
Single Pack IPM IGBT Powerex PM600HSA120 & similar Intellimod IGBT Bricks:
Meter on Diode Test Mode
BLK to C, Red to E = 0.5v +/-, swap = OL
Meter on Resistance Mode (Ohms)
E to Pin 4 = 0 Ohms
Dual Pack IPM IGBT Powerex PM300DSA120, PM200DSA120 & similar Intellimod IGBT Bricks:
Meter on Diode Test Mode
BLK to C1, Red to E1 = 0.5v +/-, swap = OL
BLK to C2, Red to E2 = 0.5v +/-, swap = OL
Meter on Resistance Mode (Ohms)
E1 to Pin 4 āPā = 0 Ohms, E2 to Pin 4 āNā = 0 Ohms
6 Pack IPM IGBT Powerex PM150CVA120 & similar Intellimod IGBT Bricks:
Meter on Diode Test Mode
BLK to P, Red to W = 0.5v +/-
BLK to P, Red to V = 0.5v +/-
BLK to P, Red to U = 0.5v +/- Swap Leads = OL
BLK to W, Red to N = 0.5v +/-
BLK to V, Red to N = 0.5v +/-
BLK to U, Red to N = 0.5v +/-
Swap Leads = OL
Meter on Resistance Mode (Ohms)
W to Pin 2 = 0 Ohms
V to Pin 6 = 0 Ohms
U to Pin 10 = 0 Ohms
N to Pin 15 = 0 Ohms
*Note: Testing the Diode portion of a 6 Pack IGBT is the same as testing a 3 phase rectifier.
If using Resistance Mode (Ohms) to test the Freewheel Diodes you should read over 100k (100,000) Ohms one way and read Open OL when you swap meter leads.
Any shorts or opens on diodes or opens on gates indicates a defective IGBT.
Check out these handy Electronics Test Equipment & Tools from Amazon Affiliate links:
Handheld LCR Meter Der De-5000: https://amzn.to/2yQxFa2
Drok Electronics Component Transistor Tester: https://amzn.to/2tRTFeS
Multifunction Meter DIY Kit tester: https://amzn.to/2KvanIk
Atlas DCA55 Semiconductor Tester: https://amzn.to/2MC395F
Peak Electronic Design: https://amzn.to/2KujjgZ